|August 20, 2010, 06:45||
Join Date: May 2009
Posts: 5Rep Power: 8
Dear Sir or Madam,
I am trying to extrude somemesh in order to get a 360° from a 6° piece.
With some geometries I just don't mange to get it, cause it appears the message "segmentation violation".
This message is quite clear, but it does not let me understand what did I do wrong.
Can anyone help me to understand what are the needed requirements in order to get a successfull extrusion?
I have a 6° piece which is good meshed and all the quality requirements are fulfilled.So It can be that I did something wrong in the association.
Any help and suggestion would be appreciated.
I can mail my geometry.
Thank you in advance.
|icem, periodic blocking, periodicity|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Periodic boundary condition||Arif||FLUENT||2||January 17, 2014 07:48|
|[ICEM] Blocking and Symmetry||BrolY||ANSYS Meshing & Geometry||32||August 24, 2012 03:13|
|Why can't I make the boundaries periodic?||Alina||FLUENT||5||April 12, 2012 14:06|
|[ICEM] Specifying Periodic Vertices Causes Mesh Overlap||Josh||ANSYS Meshing & Geometry||10||July 8, 2010 02:39|
|Must periodic oscillation give periodic results?||zonexo||Main CFD Forum||6||May 13, 2007 15:36|