CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   Incorrect boundary mesh connectivity (

rage August 25, 2010 08:51

Incorrect boundary mesh connectivity
Hi everyone,

I am working on a volume which consists of a parallelepiped with a circular outlet on one of the face. to make the outlet i have split the volume with circular face(outlet) but when i mesh it, i am getting this message "volume has incorrect boundary mesh connectivity on face-outlet". This appears only when i try to export this to fluent. Please Help...

Mohsin September 2, 2010 01:23

I just got the same problem. was searching in CFD online got your message with no reply:(. Have you got any solution?

All times are GMT -4. The time now is 00:43.