CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [GAMBIT] gambit fatal error (http://www.cfd-online.com/Forums/ansys-meshing/79848-gambit-fatal-error.html)

bugra September 6, 2010 10:55

gambit fatal error
 
Hi everybody,

while I'm meshing volume, a fatal error occurs an closing gambit. by increasing surface mesh size, I could create the volume without problem. but, after I generated it , when I tried to save, again it gives fatal error, is there anybody to say how to solve this problem?

so, the total mesh size is quite big and I'm working at a cluster.

thanks.

sidspark12 September 16, 2010 05:12

please ckeck out the RAM of ur system........

what is the no. of element...and how much is the RAM of your system...>>>?

bugra September 16, 2010 05:19

Yes, I think It s the ram problem, I have informed administrators about this problem. My mesh size is about 30 million but that's not too big for 32 gb ram I think.
However, when I decrease the mesh size up to 12 million, the problem disappears.

thanks.


All times are GMT -4. The time now is 21:45.