[GAMBIT] gambit fatal error

bugra · September 6, 2010, 10:55

Hi everybody,

while I'm meshing volume, a fatal error occurs an closing gambit. by increasing surface mesh size, I could create the volume without problem. but, after I generated it , when I tried to save, again it gives fatal error, is there anybody to say how to solve this problem?

so, the total mesh size is quite big and I'm working at a cluster.

thanks.

sidspark12 · September 16, 2010, 05:12

please ckeck out the RAM of ur system........

what is the no. of element...and how much is the RAM of your system...>>>?

bugra · September 16, 2010, 05:19

Yes, I think It s the ram problem, I have informed administrators about this problem. My mesh size is about 30 million but that's not too big for 32 gb ram I think.
However, when I decrease the mesh size up to 12 million, the problem disappears.

thanks.

September 6, 2010, 10:55	gambit fatal error	#1
bugra Member B. Selenbas Join Date: Dec 2009 Posts: 37 Rep Power: 16	Hi everybody, while I'm meshing volume, a fatal error occurs an closing gambit. by increasing surface mesh size, I could create the volume without problem. but, after I generated it , when I tried to save, again it gives fatal error, is there anybody to say how to solve this problem? so, the total mesh size is quite big and I'm working at a cluster. thanks.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CGNS Compiling	Diego	Main CFD Forum	17	December 21, 2014 01:40
nonNewtonian viscosity model	mhassani	OpenFOAM Programming & Development	5	January 7, 2013 09:27
compile errors of boundary condition "expDirectionMixed"	liying02ts	OpenFOAM Bugs	2	February 1, 2010 20:11
error while running paraFoam!	padmanathan	OpenFOAM	9	October 13, 2009 05:17
Installation OF1.5-dev	ttdtud	OpenFOAM Installation	46	May 5, 2009 02:32

September 16, 2010, 05:12		#2
sidspark12 New Member siddharth jain Join Date: Sep 2009 Posts: 16 Rep Power: 16	please ckeck out the RAM of ur system........ what is the no. of element...and how much is the RAM of your system...>>>?

September 16, 2010, 05:19		#3
bugra Member B. Selenbas Join Date: Dec 2009 Posts: 37 Rep Power: 16	Yes, I think It s the ram problem, I have informed administrators about this problem. My mesh size is about 30 million but that's not too big for 32 gb ram I think. However, when I decrease the mesh size up to 12 million, the problem disappears. thanks.