CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] Extracting point data from a spline or curve (http://www.cfd-online.com/Forums/ansys-meshing/79889-extracting-point-data-spline-curve.html)

sherifkadry September 7, 2010 17:05

Extracting point data from a spline or curve
 
Here's my question folks, I have a curve or spline and I have placed points on at various intervals, is there anyway I can write a macro which would id each point and print it to a text file? Any thoughts would be appreciated.

zeitistgeld September 8, 2010 04:15

you can use ug or proe to realize what you want, but in ICEM I've never tried this.

PSYMN December 5, 2010 20:20

See the programmers guide... I am sure this is possible, but have never done it.

Do you care about the order of the points interrogated?


All times are GMT -4. The time now is 15:58.