CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   an internal error occurre in ICEM (

qiulan September 20, 2010 22:23

an internal error occurre in ICEM
2 Attachment(s)
Hi, everybody. Here is my problem when i tried to mesh the surface. When i finished compute surface mesh using patch dependent method I checked and found that two curves forming a sharp angle. Knowing that the two curves have no influence on connectivity between surfaces, so I wanted to delete them. By this time, a spread sheet was popped up saying "an internal error has occured: syntax error in expression 'emethod':variable references require preceding$...." What does this mean? Why it happens every time I perform this practice? What can I do then?
Many thanks!

PSYMN September 21, 2010 11:06
I can't tell from here...

I suggest that any failures be reported to

Ideally you can include the case with instructions so they can reproduce it and get the same crash... If we can crash it, we can fix it.

Best regards,


qiulan September 22, 2010 10:14

Dear Semon,
I have reported the failures to Thank you so much!
Best wishes!
Qiulan Zeng

All times are GMT -4. The time now is 09:01.