CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   Extrusion of 2D to 3D block following a curve (http://www.cfd-online.com/Forums/ansys-meshing/80330-extrusion-2d-3d-block-following-curve.html)

risku9 September 22, 2010 13:03

Extrusion of 2D to 3D block following a curve
 
Hi!

I'm new using ICEM, and I need to make a multiblock mesh inside a curved duct. To explain it, I've tried to use the command 2D to 3D following a curve but the extrusion continues straight and didn't follow my curve. I'm not sure if my problem is clear, it's quiet difficult to explain :S. I hope somebody can help me please!!!Thanks by the way.


All times are GMT -4. The time now is 04:12.