 |
 |
 |
|
|
|
[Sponsors] | ||||
October 24, 2010, 11:20
|
remeshing for large mesh motion
|
#1 |
|
New Member
pedram
Join Date: Aug 2010
Posts: 8
Rep Power: 15  |
hi there,
im trying to simulate free falling of a rigid ball into calm water with free surface. i've created a 3d gtm mesh with one element thickness to have a 2d simulation. then imported into cfx-pre, wrote expressions for ball motion, and apply it on ball boundry. then started cfx-solver, everything goes well until negative volume error after 200 iterations! i've found that minimum value of "orthogonality angle" will drop below 1! then i've read THIS tutorial about re-meshing and found that i have to do something with "replay manager" but this page is a brief overview and don't have detail information also i couldn't find a step by step solution for it  my problem is somehow the same as video in that tuutorial! could someone please tell me how to do re-meshing? |
|
|
|
|
|
October 29, 2010, 17:55
|
|
#2 |
|
New Member
pedram
Join Date: Aug 2010
Posts: 8
Rep Power: 15 |
any idea?
any idea? |
|
|
|
|
|
 |
| Tags |
| moving mesh, re-meshing |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 06:42 |
| [snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 19:43 |
| Mesh Motion pitch on a hull | Seb | CFX | 1 | February 23, 2009 13:04 |
| Help with Mesh motion preview | Mustafa Ayad | FLUENT | 2 | January 20, 2009 22:40 |
| Mesh motion Hex cells vs tets | kev4573 | OpenFOAM Running, Solving & CFD | 6 | December 13, 2007 14:37 |
Linear Mode
