CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [Other] OpenFoam Mesh to Fluent Mesh, 2D (http://www.cfd-online.com/Forums/ansys-meshing/81839-openfoam-mesh-fluent-mesh-2d.html)

lordvon November 8, 2010 14:48

OpenFoam Mesh to Fluent Mesh, 2D
 
I have converted and successfully read a converted mesh file into fluent (from openfoam), but fluent only recognizes the mesh as 3d, when I want 2d. Openfoam always uses 3d meshes, even if the simulation is 2d (the mesh is an extrusion). How can I get fluent to recognize this is an extrusion and run in 2D?


All times are GMT -4. The time now is 17:23.