|November 23, 2010, 05:08||
whenever i try opening a .jou file, it just does not open..properly
Join Date: Nov 2010
Posts: 8Rep Power: 6
Hi guys..I am a new user of GAMBIT and FLUENT, and i am bit confused, the thing is that, i have made my model with the meshing, and then when i save it and try to open it later(.jou), it just does not open properly..it starts...giving ..''error in command'' a thousand times....and looks like its doing some simulation by itself...[ 0 -----100%] ..what to do?
Note: a friend told me just try to clean that journal file and save it at another location, but this doesnt work either, i tried it..
|file format, filename|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Opening a .jou file in FLUENT||Martin_D||FLUENT||5||October 12, 2010 10:15|
|ParaView Compilation||jakaranda||OpenFOAM Installation||3||October 27, 2008 12:46|
|Paraview command not found||hardy||OpenFOAM Paraview & paraFoam||7||September 18, 2008 04:59|
|Problem with rhoSimpleFoam||matteo_gautero||OpenFOAM Running, Solving & CFD||0||February 28, 2008 07:51|
|Results saving in CFD||hawk||Main CFD Forum||16||July 21, 2005 20:51|