[alnabhani]

hellow there

I have the follwoing domain:
2.jpg

the red circled small edge is the inlet, and the green circled edge is the outlet. i want to mesh this domain to get good and reasonable results.

the best mesh i've obtained using ANSYS is the following one :
1.jpg
which contains many problems in the mesh itself.

can anybody help me in constructing this mesh using ICEM CFD ?

[jeevankumarb]

Hello alnabhani

The geometry looks relatively simpler, you can go for Hexa meshing, you can find few related tutorial and videos for generating hexa grid for aerofoils.

Regards
jeevan

[PSYMN]

Even within ANSYS Meshing, you could draw some lines to chop up the domain a bit into mappable (4 cornered) patches that the mesher will give a better mesh on.

Or perhaps you would rather ask for a triangle mesh from ANSYS Meshing?

If you decide to try ICEM CFD Hexa, you will find a 3 part tutorial on our youtube site...

http://www.youtube.com/user/ansysinc#p/u/8/tYrbScUH9RE



-----------------------------------------
Please help guide development at ANSYS by filling in these surveys

Public ANSYS ICEM CFD Users Survey

This second one is more general (Gambit, TGrid and ANSYS Meshing users welcome)...

CFD Online Users Survey