|
[Sponsors] |
December 2, 2010, 06:10 |
Meshing NACA0012 Airfoil
|
#1 |
New Member
Join Date: Aug 2010
Posts: 4
Rep Power: 15 |
hellow there
I have the follwoing domain: 2.jpg the red circled small edge is the inlet, and the green circled edge is the outlet. i want to mesh this domain to get good and reasonable results. the best mesh i've obtained using ANSYS is the following one : 1.jpg which contains many problems in the mesh itself. can anybody help me in constructing this mesh using ICEM CFD ? |
|
December 2, 2010, 06:42 |
|
#2 |
Member
jeevan kumar
Join Date: Mar 2009
Posts: 88
Rep Power: 17 |
Hello alnabhani
The geometry looks relatively simpler, you can go for Hexa meshing, you can find few related tutorial and videos for generating hexa grid for aerofoils. Regards jeevan |
|
December 3, 2010, 09:50 |
Map it...
|
#3 |
Senior Member
Simon Pereira
Join Date: Mar 2009
Location: Ann Arbor, MI
Posts: 2,663
Blog Entries: 1
Rep Power: 47 |
Even within ANSYS Meshing, you could draw some lines to chop up the domain a bit into mappable (4 cornered) patches that the mesher will give a better mesh on.
Or perhaps you would rather ask for a triangle mesh from ANSYS Meshing? If you decide to try ICEM CFD Hexa, you will find a 3 part tutorial on our youtube site... http://www.youtube.com/user/ansysinc#p/u/8/tYrbScUH9RE ----------------------------------------- Please help guide development at ANSYS by filling in these surveys Public ANSYS ICEM CFD Users Survey This second one is more general (Gambit, TGrid and ANSYS Meshing users welcome)... CFD Online Users Survey |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Airfoil Meshing Scheme in Gambit | J. Weiler | FLUENT | 6 | October 2, 2011 15:41 |
[Other] Ansys meshing airfoil and / or compressor blades | baw192 | ANSYS Meshing & Geometry | 8 | September 23, 2011 00:43 |
Oscillating Airfoil - Dynamic meshing or user-defined velocity profile. | DarrenC | Main CFD Forum | 5 | July 19, 2010 22:33 |
[GAMBIT] Meshing airfoil using .dat file problem | creggie | ANSYS Meshing & Geometry | 10 | June 27, 2010 19:24 |
[GAMBIT] NACA0012 meshing problem | parvez2683 | ANSYS Meshing & Geometry | 3 | June 24, 2009 00:46 |