CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   Questions about ANSYS ICEM CFD tutorial (http://www.cfd-online.com/Forums/ansys-meshing/82763-questions-about-ansys-icem-cfd-tutorial.html)

pquispea_m5 December 4, 2010 21:52

Questions about ANSYS ICEM CFD tutorial
 
hi,

i have a few question about the manual in section 3.7.2 "Tutorial Opera M6 Wing with 0.54 M":

1) In the visualization of result iget pressures over the wing. how can i get the dimension of this values? Are they in Mpa in this case?

2) If i want to get stresses and deformations on wing (from root to tip), how can i export the pressures values (i understand it as loads) to ANSYS Workbench? so i assign boundary conditions and materials properties to calculate it. Or is it calculated in ANSYS ICEM CFD directly? Thanks

Greets,
Pablo

pquispea_m5 December 5, 2010 16:24

Any answer please.
grts,
Pablo

PSYMN December 5, 2010 16:30

That tutorial shows post in ICEM CFD Visual3 Post... It is possible to map these results to FEA output. I made a tutorial for that years ago, but I just did a search and couldn't find it.

I recommend you use CFD Post in ANSYS Workbench which makes it much easier. There are a number of new tutorials explaining the process.

Sorry, I have switched to CFD Post several years ago and don't have a fresh memory about Visual3...

Usually, there is a legend to help you interpret the colors. You can also draw lines to use as the Xaxis of a 2D pressure plot, etc.

pquispea_m5 December 5, 2010 16:58

thanks for your answer simon. we are in contact
grts,
Pablo


All times are GMT -4. The time now is 02:24.