Exporting surfaces inside the control volume (interior)

bigmoneylou · December 9, 2010, 17:34

Hi everybody.

I tried to define surfaces inside my control volume in order to get the velocity and the mass flow true those when I post process the data. I did this with Ansys workbench (design modeler) . Everything works fine until I open fluent, I have the following message:skipping zone... (not referenced by grid). So the surfaces are not loaded. My goal was to define those surfaces as interior.

If you have any ideas it would be great, those surfaces have very complex shapes so I cannot generate them with planes with any post processing software.

Thanks,

Louis

PSYMN · January 8, 2011, 16:16

I think this means you have a zone (named selection of geometry), but no mesh formed in that named selection... Once you get to fluent, it compares the list of bocos with the actual mesh and can't find a mesh for that boco.

December 9, 2010, 17:34	Exporting surfaces inside the control volume (interior)	#1
bigmoneylou New Member louis moreaux Join Date: Dec 2010 Posts: 2 Rep Power: 0	Hi everybody. I tried to define surfaces inside my control volume in order to get the velocity and the mass flow true those when I post process the data. I did this with Ansys workbench (design modeler) . Everything works fine until I open fluent, I have the following message:skipping zone... (not referenced by grid). So the surfaces are not loaded. My goal was to define those surfaces as interior. If you have any ideas it would be great, those surfaces have very complex shapes so I cannot generate them with planes with any post processing software. Thanks, Louis

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mesh grid a control volume of propeller	vsun	FLOW-3D	3	October 26, 2009 23:01
modeling of volume inside volume in gambit	rahulsharma	FLUENT	3	October 23, 2009 08:19
How to control the boundedness of volume fraction?	Angela	Main CFD Forum	2	December 5, 2002 04:24
Control Volume Gradient	Barry	Main CFD Forum	8	September 27, 2001 12:28
Control Volume FEM	Charles	Main CFD Forum	0	February 26, 1999 04:19

January 8, 2011, 16:16		#2
PSYMN Senior Member Simon Pereira Join Date: Mar 2009 Location: Ann Arbor, MI Posts: 2,663 Blog Entries: 1 Rep Power: 47	I think this means you have a zone (named selection of geometry), but no mesh formed in that named selection... Once you get to fluent, it compares the list of bocos with the actual mesh and can't find a mesh for that boco.