 |
 |
 |
|
|
|
[Sponsors] | ||||
January 13, 2011, 20:24
|
Cell zone
|
#1 |
|
New Member
Fabiano de Souza Mendes
Join Date: Jan 2011
Posts: 6
Rep Power: 15  |
Hello everybody,
I'm doing a simulate in a rectangular kiln and I want to put inside it a porous solid. I am working with software FLUENT and according to tutorials I should create a cell zone. Can I create a cell zone in DM or in the ANSYS Meshing? What is the best way to create it? Thank you very much Fabian |
|
|
|
|
|
January 14, 2011, 10:43
|
Named Selections...
|
#2 |
|
Senior Member
Simon Pereira
Join Date: Mar 2009
Location: Ann Arbor, MI
Posts: 2,663
Blog Entries: 1
Rep Power: 47 |
This should help... I get into Cell Zones at the very end...
http://www.youtube.com/watch?v=-6Z2v8geroQ This is one of the most frequently asked questions... |
|
|
|
|
|
|
January 14, 2011, 10:53
|
|
#3 |
|
New Member
Fabiano de Souza Mendes
Join Date: Jan 2011
Posts: 6
Rep Power: 15 |
Thank you very much...
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [CGNS] CGNS converters available | mbeaudoin | OpenFOAM Meshing & Mesh Conversion | 137 | December 14, 2018 04:20 |
| Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
| Problem in IMPORT of ICEM input file in FLUENT | csvirume | FLUENT | 2 | September 9, 2009 01:08 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
| Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |
Linear Mode
