CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [DesignModeler] create edge from points (http://www.cfd-online.com/Forums/ansys-meshing/84481-create-edge-points.html)

code_source January 31, 2011 10:58

create edge from points
 
Hello,
how to create an edge from three points on DM?
On Gambit:

Code:

edge create center "c1" major "c2" onedge "c3" start 0 end 360 ellipse
Thank you for your help

Ali_M January 31, 2011 18:25

I'm fairly new to DesignModeler, but from what I understand you can insert the points manually and then use the 'Line From Points' option and create a line between them.


All times are GMT -4. The time now is 14:08.