Home > Forums > ANSYS Meshing & Geometry

[DesignModeler] Create ellipse from 3 points

Mark Forums Read

Reply

February 1, 2011, 03:30	Create ellipse from 3 points	#1
code_source New Member fatma Join Date: Jan 2011 Posts: 9 Rep Power: 4	Hello How to create an ellipse from 3 points on DesignModeler? Thank you a lot

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Actuator disk model	audrich	FLUENT	0	September 21, 2009 07:06
Where's the singularity/mesh flaw?	audrich	FLUENT	3	August 4, 2009 01:07
BlockMeshmergePatchPairs	hjasak	OpenFOAM Native Meshers: blockMesh	11	August 15, 2008 07:36
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55
Create 2D hexa block from points	alexey	CFX	1	June 22, 2006 07:49

All times are GMT -4. The time now is 12:54.