CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] mesh quality problem in fluent (http://www.cfd-online.com/Forums/ansys-meshing/85365-mesh-quality-problem-fluent.html)

turbotel February 23, 2011 23:24

mesh quality problem in fluent
 
I'm using ICEM CFD to create a mesh and ortho quality is above 0.3 and tgrid skewness also less than 0.8 but in fluent it shoes some the cell's orto qulaity is below 0.1.
earlier fluent (i.e: fluent 12.0) it checking skewness of the cell and current version checking ortho quality & aspect ration.
what's the advantages of this mesh check over earlier mesh check parameter?


All times are GMT -4. The time now is 17:13.