 |
 |
 |
|
|
|
[Sponsors] | ||||
February 23, 2011, 22:24
|
mesh quality problem in fluent
|
#1 |
|
New Member
Join Date: Nov 2010
Posts: 26
Rep Power: 15  |
I'm using ICEM CFD to create a mesh and ortho quality is above 0.3 and tgrid skewness also less than 0.8 but in fluent it shoes some the cell's orto qulaity is below 0.1.
earlier fluent (i.e: fluent 12.0) it checking skewness of the cell and current version checking ortho quality & aspect ration. what's the advantages of this mesh check over earlier mesh check parameter? |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
| Mesh quality and wall function in FLUENT - k-omega model | newcomer | ANSYS Meshing & Geometry | 1 | May 19, 2011 03:00 |
| Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |
| [Commercial meshers] A problem about Importing mesh from fluent | aderliner | OpenFOAM Meshing & Mesh Conversion | 1 | February 13, 2007 14:44 |
| A problem about Importing mesh from fluent | aderliner | OpenFOAM Running, Solving & CFD | 0 | December 18, 2006 23:05 |
Linear Mode
