CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   Wind tunnel hexa meshing in ICEM CFD 12.1 (http://www.cfd-online.com/Forums/ansys-meshing/85396-wind-tunnel-hexa-meshing-icem-cfd-12-1-a.html)

matheusguzella February 24, 2011 10:16

Wind tunnel hexa meshing in ICEM CFD 12.1
 
1 Attachment(s)
Hello,

I'm using ICEM CFD 12.1 for meshing a wind tunnel with hexa elements.. but I don't know (I don't have much experience with hexa meshing) how to make to correct associations, since I'm using only half of the model (as can be checked on the file attached).. I'm meshing this model for a project on my university, I tried to see the tutorial but I couldn't solve this problem..

Best Regards,

Matheus Guzella

PSYMN March 14, 2011 17:14

If you took the section 45 degrees from this one, it would have 4 good corners and would be much easier to hexa mesh than this triangular section...

However, you can still handle this triangular section with a quarter ogrid (aka Ygrid) or wedge (collapsed hexa) topology...


All times are GMT -4. The time now is 19:53.