CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   Multiple Edges when merging Hex/Tet (http://www.cfd-online.com/Forums/ansys-meshing/86520-multiple-edges-when-merging-hex-tet.html)

pz1337 March 24, 2011 12:32

[Remove please]
 
1 Attachment(s)
-------------

PSYMN March 25, 2011 18:24

Associate Edge to curves?
 
Merge Meshes is very robust, but has a few very specific rules... I have gone into these in detail in several other posts, you can probably find more on this there...

My guess here is that you are breaking the rule that the merge face on both sides must be associated to the perimeter. This is automatic in Tetra, but for Hexa, it requires that you associate the edges with the curves...

Check your associations...

pz1337 March 25, 2011 18:45

The edges are associated to the curves which border the connecting surfaces.

I will search for more rules in your posts.


All times are GMT -4. The time now is 21:33.