Domain size icem cfd block mesh

erhan61 · March 29, 2011, 04:18

ı wanna do block mesh with icem cfd . For example ı did 3-d rectangular volume model. When ı put the fit window command domain size for example min:0,0,0 max:0,20,20 but when ı create block mesh, domain size shows min:0,0,-2.567e-10 max:0,20,20 why? how can ı fix this situation.how can ı do that this value also is zero?

BrolY · March 29, 2011, 09:39

It's not a problem at all. A value of -2.567e-10 is so small, that it won't change anything. It depends on the tolerance ICEM has.

Also, keep in mind that you are going to mesh your domain, and if your geometry is not perfect, it's not an issue until your smallest mesh elements size is bigger than your biggest "geometric" gap size.

An example: if you can mesure a gap of 0.00001 meter between two surfaces of your geometry, and if your smallest elements size is 0.1 meter, it would not be an issue. The mesh won't "see" the gap because it's so small compared to your smallest elements.

March 29, 2011, 04:18	Domain size icem cfd block mesh	#1
erhan61 New Member erhan Join Date: Apr 2009 Posts: 3 Rep Power: 17	ı wanna do block mesh with icem cfd . For example ı did 3-d rectangular volume model. When ı put the fit window command domain size for example min:0,0,0 max:0,20,20 but when ı create block mesh, domain size shows min:0,0,-2.567e-10 max:0,20,20 why? how can ı fix this situation.how can ı do that this value also is zero?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Import Mesh from ICEM CFD to CFX	Andre Almeida	CFX	16	April 19, 2016 03:42
Superlinear speedup in OpenFOAM 13	msrinath80	OpenFOAM Running, Solving & CFD	18	March 3, 2015 05:36
prob while exporting icem cfd hexa mesh to fluent	mani	CFX	4	March 7, 2007 03:41
About Mesh size setting in ICEM	Eric	CFX	2	July 11, 2006 08:16
Mesh from ICEM CFD to CFX ! Error ! Why ? Thanks !	Vu Trinh Tuan	CFX	11	March 28, 2005 19:04

March 29, 2011, 09:39		#2
BrolY Senior Member AB Join Date: Sep 2009 Location: France Posts: 323 Rep Power: 21	It's not a problem at all. A value of -2.567e-10 is so small, that it won't change anything. It depends on the tolerance ICEM has. Also, keep in mind that you are going to mesh your domain, and if your geometry is not perfect, it's not an issue until your smallest mesh elements size is bigger than your biggest "geometric" gap size. An example: if you can mesure a gap of 0.00001 meter between two surfaces of your geometry, and if your smallest elements size is 0.1 meter, it would not be an issue. The mesh won't "see" the gap because it's so small compared to your smallest elements.