CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [GAMBIT] cylinder pipe (http://www.cfd-online.com/Forums/ansys-meshing/87012-cylinder-pipe.html)

asaleghahreman April 8, 2011 16:10

cylinder pipe
 
I made a cylinder in gambit,I put the circle face of this cylinder as inflow and the other circle outflow.but when
I put it in fluent and start it,it gives me floating point error.without any iteration.what is the problem?who knows?Is the problem from my set up in fluent or my model in gambit?just by making cylinder,will fluent know it as pipe?

-mAx- April 11, 2011 02:37

if the fluent check mesh doesn't return any problem, then your issue lies on the setup


All times are GMT -4. The time now is 12:10.