CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [DesignModeler] how to define the unit convertion in workbench (http://www.cfd-online.com/Forums/ansys-meshing/87070-how-define-unit-convertion-workbench.html)

just like wind April 11, 2011 03:06

how to define the unit convertion in workbench
 
:confused:
Hi, I built two modles using the same unit (m) and now I want to import one model into the other one, I did this before and the unit did not change. however, this time the unit of the imported model automatically converted to mm. anyone can help? thx in advance!

just like wind April 11, 2011 19:18

anyone can help? Please help! I still cannot control the unit. :(

just like wind April 13, 2011 07:24

:( rely on myslef


All times are GMT -4. The time now is 01:38.