|
[Sponsors] |
April 13, 2011, 05:14 |
Help making Surface Urgent !!!!
|
#1 |
Member
anonymous
Join Date: Jan 2011
Posts: 42
Rep Power: 15 |
Hi All ;
If anyone help me to make surface on two sides of model described in the picture . |
|
April 13, 2011, 05:45 |
|
#2 |
Member
anonymous
Join Date: Jan 2011
Posts: 42
Rep Power: 15 |
this is the result when selecting curves to make surface !
|
|
April 13, 2011, 10:45 |
|
#3 |
Senior Member
Simon Pereira
Join Date: Mar 2009
Location: Ann Arbor, MI
Posts: 2,663
Blog Entries: 1
Rep Power: 47 |
You are trying to loft, that works if the curves are roughly parallel. It tries to connect each curve in the series...
What you need is Create surface from 2 to 4 curves... You actually have more, but they are planar so it can figure it out. If the first attempt fails, it may give a large untrimmed surface. Just run build topology and it will trim that surface. Then you can delete the outer portion. Another option is to just create a surface (2 to 4 curves from the inlet and outlet side curves... Then trim out the two small squares (using build topo and then delete).
__________________
----------------------------------------- Please help guide development at ANSYS by filling in these surveys Public ANSYS ICEM CFD Users Survey This second one is more general (Gambit, TGrid and ANSYS Meshing users welcome)... CFD Online Users Survey |
|
April 13, 2011, 11:50 |
|
#4 | |
Member
anonymous
Join Date: Jan 2011
Posts: 42
Rep Power: 15 |
Quote:
|
||
April 13, 2011, 12:43 |
|
#5 |
Senior Member
Simon Pereira
Join Date: Mar 2009
Location: Ann Arbor, MI
Posts: 2,663
Blog Entries: 1
Rep Power: 47 |
Odd, you could either fill that in with another surface, or you could try my second suggestion and stretch a surface from one side of the box to the other (just using 2 curves) and then build topo and cut out the small boxes...
__________________
----------------------------------------- Please help guide development at ANSYS by filling in these surveys Public ANSYS ICEM CFD Users Survey This second one is more general (Gambit, TGrid and ANSYS Meshing users welcome)... CFD Online Users Survey |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
[Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
Recover surface from surface mesh in IcemCFD | Jerry Tanner | CFX | 0 | August 20, 2008 12:48 |
Making arc on circle surface | rosol | FLUENT | 2 | October 11, 2007 13:55 |
free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin | Kaushik | FLUENT | 1 | May 8, 2000 06:47 |