[ANSYS Meshing] Surface Body Named Selections for OpenFoam

slowtype · April 19, 2011, 15:23

Hello

I am attempting to mesh an imported solid body as a fluid with surface bodies within it acting as baffles. This is to be used in OpenFoam

The problem: surface body patches are not recognized/imported into openfoam.

I was previously using Gambit with the following workflow:

import part
split volumes with faces
mesh
set zone name and type

I am inclined to think the problem is related to the fact that I can't figure out how to split the volume in ANSYS Mesh as well as set zone types beyond named selections.

Any ideas?

Thanks

slowtype · April 20, 2011, 09:37

Additional information:

This model imports the same way into Fluent.

The surface bodies are selectable and visible in DM and the mesher.

But when the model is opened within Fluent or Foam the surface bodies are no longer visible.

slowtype · April 20, 2011, 10:35

Multiple bodies in DM needed to be combined into a single part

April 19, 2011, 15:23	Surface Body Named Selections for OpenFoam	#1
slowtype New Member Andrew Join Date: Nov 2010 Posts: 12 Rep Power: 15	Hello I am attempting to mesh an imported solid body as a fluid with surface bodies within it acting as baffles. This is to be used in OpenFoam The problem: surface body patches are not recognized/imported into openfoam. I was previously using Gambit with the following workflow: import part split volumes with faces mesh set zone name and type I am inclined to think the problem is related to the fact that I can't figure out how to split the volume in ANSYS Mesh as well as set zone types beyond named selections. Any ideas? Thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with compile the setParabolicInlet	ivanyao	OpenFOAM Running, Solving & CFD	6	September 5, 2008 20:50
Flame Surface Density.	Burn Ing	Main CFD Forum	3	December 5, 2004 17:12
solid edge problem....can you help?	cindy	Main CFD Forum	3	April 5, 2004 13:43
gravitational force for free surface flow	Jongtae Kim	Main CFD Forum	1	July 2, 2000 11:57
Any Body got a Free Surface Solution in FIDAP	Dr. Ahmed Hassaneen	Main CFD Forum	2	November 8, 1999 14:59

April 20, 2011, 09:37		#2
slowtype New Member Andrew Join Date: Nov 2010 Posts: 12 Rep Power: 15	Additional information: This model imports the same way into Fluent. The surface bodies are selectable and visible in DM and the mesher. But when the model is opened within Fluent or Foam the surface bodies are no longer visible.

April 20, 2011, 10:35		#3
slowtype New Member Andrew Join Date: Nov 2010 Posts: 12 Rep Power: 15	Multiple bodies in DM needed to be combined into a single part