|April 20, 2011, 11:20||
Meshing Issues: Boundary Entity.....
Join Date: Apr 2011
Posts: 3Rep Power: 6
I'm new to this forum and relatively new to CFD in general so i'm hoping someone on here can be of help!
Basically I have modelled a wind tunnel (and car) and equipped it with all of the necessary boundary and continuum types (Velocity Inlet/Pressure Outlet etc) When I attempt to export my model to Fluent I get the following error: Boundary Entity "car" does not contain any valid entity and will not be written. I purposely did not mesh the car as it was my understanding that if I did not mesh it and set it's surfaces to "wall" Fluent would model the flow around the body-shape of the car?
Having exported the model into Fluent and displayed it, the car appeared to have gone completely (I was expecting a white sillohuette I suppose). So then I attempted to mesh the car - exported it and the same thing appears to have happened! No car!
I may be making some totally fundamental and rookie errors here so if anyone could shed some light on this it would be much appreciated!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Implementation of boundary conditions for FVM||Tom||Main CFD Forum||7||August 26, 2014 05:58|
|gambit boundary layer meshing||Rick||FLUENT||6||April 26, 2010 05:01|
|problem in meshing a periodic boundary||dumas||FLUENT||4||March 8, 2006 11:54|
|Boundary conditions?||Tom||Main CFD Forum||0||November 5, 2002 02:54|
|boundary layer meshing||santosh||FLUENT||6||November 1, 2001 18:54|