[ICEM] Problem with zones/bocos exporting ICEM model to Fluent

hectordiaz · May 3, 2011, 03:27

Hello,

First of all, I am very new in the CFD world. I have started working on my Master Thesis and I need to simulate a 2D combustion chamber.

In my model, I have 5 inlets represented by edges. I have created parts, meshed the model and assigned them boundary conditions. The problem is that once I export the model to Fluent, I can't find this parts I need to introduce the boundary conditions.

I have searched the forum and I found a few posts with a similar problem but mine seems not to work. I think I am following all the right steps and I can't find what I am doing wrong.

Any suggestions?

Thanks in advance.

PS Sorry if I can't explain myself properly, the CFD is new for me plus my English is not very good.

hectordiaz · May 3, 2011, 04:24

Ok, I think it is fixed. I had to manually associate the mesh around the elements I wanted and now I can see them in fluent.

May 3, 2011, 03:27	Problem with zones/bocos exporting ICEM model to Fluent	#1
hectordiaz New Member Hector Diaz Join Date: May 2011 Posts: 17 Rep Power: 14	Hello, First of all, I am very new in the CFD world. I have started working on my Master Thesis and I need to simulate a 2D combustion chamber. In my model, I have 5 inlets represented by edges. I have created parts, meshed the model and assigned them boundary conditions. The problem is that once I export the model to Fluent, I can't find this parts I need to introduce the boundary conditions. I have searched the forum and I found a few posts with a similar problem but mine seems not to work. I think I am following all the right steps and I can't find what I am doing wrong. Any suggestions? Thanks in advance. PS Sorry if I can't explain myself properly, the CFD is new for me plus my English is not very good.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
problem with UDF for (v2-f) turbulence model in fluent	artemiss1984	Fluent UDF and Scheme Programming	6	January 17, 2014 05:50
problem exporting from icem to fluent	jc_muaddib	FLUENT	1	June 16, 2010 04:16
Icem to FLUENT problem	Babak	FLUENT	0	June 10, 2010 17:14
multiphase mixing Problem with MRF model in MixSim	Srinivas	FLUENT	0	October 17, 2005 06:35
Import ICEM Mesh to Fluent	Fluent Beginner	FLUENT	5	June 23, 2004 00:27

May 3, 2011, 04:24		#2
hectordiaz New Member Hector Diaz Join Date: May 2011 Posts: 17 Rep Power: 14	Ok, I think it is fixed. I had to manually associate the mesh around the elements I wanted and now I can see them in fluent.