|
[Sponsors] |
Grid quality check for impingement configuration |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 4, 2011, 09:13 |
Grid quality check for impingement configuration
|
#1 |
Member
Join Date: Jan 2011
Posts: 37
Rep Power: 15 |
Hi,
I have doubt regarding my mesh quality. I have an impingement plate with inlet and outlet as shown in the the figure. The thing is yplus on the avereage if i calculate on the buckle is around 1.3. but at some points it is 2.7. so can is the mesh quality acceptable?. And i saw in some discussions that the yplus sholud be less than 1. And when i see the yplus avereaged over the whole fluid solid interface it is around 0.49. Thanks in advance for your reply, Krishna |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
critical error during installation of openfoam | Fabio88 | OpenFOAM Installation | 21 | June 2, 2010 03:01 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
Grid Independent Solution | Chuck Leakeas | Main CFD Forum | 2 | May 26, 2000 11:18 |
Grid Quality and the Solution | Faraz | Main CFD Forum | 4 | January 10, 2000 18:18 |
LES & grid quality | Ales Skotak | Main CFD Forum | 1 | July 23, 1999 09:46 |