CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   problem with hex mesh for impingement plate (http://www.cfd-online.com/Forums/ansys-meshing/88168-problem-hex-mesh-impingement-plate.html)

rskrishna87 May 10, 2011 07:33

problem with hex mesh for impingement plate
 
Hi guys,

I got the folowing message when i was trying to generate hexagonal mesh on an impingement plate:
Running hexa-dominant mesher...
{expecting 2 shells on edge 152 769 found 3
}
error orienting normals, perhaps there is more than one region
error in output_boundaries
Hex Dominant meshing failed
Performing a mesh flood fill...
element containing material point FLUID_1/EXTENDED_FLUID_2_MATPOINT.1 was not found
done mesh flood fill
Can anyone tell me what is the reason for this?

Thanks in advance,

Krishna


All times are GMT -4. The time now is 07:02.