 |
 |
 |
|
|
|
[Sponsors] | ||||
May 10, 2011, 07:33
|
problem with hex mesh for impingement plate
|
#1 |
|
Member
Join Date: Jan 2011
Posts: 37
Rep Power: 4  |
Hi guys,
I got the folowing message when i was trying to generate hexagonal mesh on an impingement plate: Running hexa-dominant mesher... {expecting 2 shells on edge 152 769 found 3 } error orienting normals, perhaps there is more than one region error in output_boundaries Hex Dominant meshing failed Performing a mesh flood fill... element containing material point FLUID_1/EXTENDED_FLUID_2_MATPOINT.1 was not found done mesh flood fill Can anyone tell me what is the reason for this? Thanks in advance, Krishna |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Moving mesh problem | Geon-Hong | FLUENT | 3 | April 5, 2010 03:24 |
| external flow with snappyHexMesh | chelvistero | OpenFOAM | 11 | January 15, 2010 19:43 |
| Mesh Deformation Problem | Virag Mishra | CFX | 0 | October 9, 2007 00:37 |
| The problem with GAMBIT - using two mesh sizes. | Owen | FLUENT | 2 | June 22, 2005 05:16 |
| unstructured vs. structured grids | Frank Muldoon | Main CFD Forum | 1 | January 5, 1999 10:09 |
Linear Mode
