|May 17, 2011, 15:57||
Meshing this figure
Join Date: May 2011
Posts: 15Rep Power: 7
I am trying to mesh the figure attached. I can make a hex mesh perfectly fine, but the question I have is how to make the mesh so that FLUENT recognizes my inlet hole on the surface. Basically, the small circle and one of the big circle are the inlet while the other is the outlet.
|May 18, 2011, 00:35||
Join Date: Oct 2010
Posts: 303Rep Power: 10
Before building the Hex mesh you need to close the smaller and bigger holes ( the inlets and the outlet) with surfaces. Associate the blocking faces with the respective surfaces in ICEM CFD. When you import this mesh into FLUENT you can assign the inlet and outlet boundary conditions to the respective surfaces.
I'd suggest that you read the section on BCs in the FLUENT help manual and the section on block associations in the ICEM CFD documentation. Basic tutorials in ICEM and FLUENT can help you gain a better insight
|Thread||Thread Starter||Forum||Replies||Last Post|
|Best Meshing scheme for Cylinder||Nutrex||Main CFD Forum||4||July 29, 2008 11:03|
|Meshing locks workbench window.||andy2o||CFX||0||February 1, 2008 06:01|
|Abt: Schlieren figure in Tecplot using data||jinwon park||Tecplot||2||December 27, 2007 07:48|
|Singularity of grid?Volume meshing vs face meshing||Ken||Main CFD Forum||0||September 4, 2003 11:09|
|Volume Meshing & Face Meshing? singularity of grid||ken||FLUENT||0||September 4, 2003 11:08|