CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [DesignModeler] show command (

japer May 25, 2011 19:48

show command
I am trying to kill elements in Ansys Workbench, Windows, simulation is descibed in command line, when I try to plot by plnsol,temp it says that

*** NOTE *** Display device has not yet been specified with the /SHOW command. Display commands ignored.

I guess i should give the device type by /show, <device type> , any idea what would it be? under unix it's x11, x3d, but on windows?

I would be thankfull for any kind of help.


All times are GMT -4. The time now is 20:08.