CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] the ball-to-wall contact area (http://www.cfd-online.com/Forums/ansys-meshing/88824-ball-wall-contact-area.html)

shanshanbu May 26, 2011 22:25

the ball-to-wall contact area
 
1 Attachment(s)
hello,In order to avoid bad mesh quality at ball-to-wall contact point,area-contacts between balls and walls were applied.However,I found that the mesh quality at area contact was not easy to be controlled. I used tetra mesh and octree method.I wonder whther i need to creat structured mesh for this geometry?
I will be very grateful for any suggestions。


All times are GMT -4. The time now is 17:20.