|
[Sponsors] |
May 26, 2011, 22:25 |
the ball-to-wall contact area
|
#1 |
New Member
shanshanbu
Join Date: Apr 2011
Posts: 3
Rep Power: 15 |
hello,In order to avoid bad mesh quality at ball-to-wall contact point,area-contacts between balls and walls were applied.However,I found that the mesh quality at area contact was not easy to be controlled. I used tetra mesh and octree method.I wonder whther i need to creat structured mesh for this geometry?
I will be very grateful for any suggestions。 Last edited by shanshanbu; May 26, 2011 at 23:27. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic contact angle | rmousavibt | Fluent UDF and Scheme Programming | 12 | October 31, 2021 22:38 |
Superlinear speedup in OpenFOAM 13 | msrinath80 | OpenFOAM Running, Solving & CFD | 18 | March 3, 2015 05:36 |
UDF to Access Wall Normal Concentration Gradient | Daniel Tanner | Fluent UDF and Scheme Programming | 4 | February 18, 2015 14:35 |
Tomiyama wall lubrication force | Edy | OpenFOAM | 10 | December 13, 2010 11:41 |
Wall functions | tutlhino | OpenFOAM Pre-Processing | 0 | July 2, 2007 05:04 |