|June 8, 2011, 06:10||
Join Date: Jun 2011
Posts: 1Rep Power: 0
I would like to simulate a flow around a fin to know the strength inside and the deformation.
I use this geometry, a bloc and a fin imported by an .iges files.
When i try to mesh them i have this message "volume 1 has invalid topology for mapped brick meshing".
How can i mesh it with a tetra meshing or another meshing?
I have tried with multiphysic licence and structural/FLotran? Witch licence is the best for this simulation?
I use for the fin the element Solidshell "SOLSH190" because i want to simulate a composite (composite in area and another material orthotrope inside the fin) and for the block i use the FLOTRAN3D element "FLUID142". Is it adapted?
Thank you for any help
|Thread||Thread Starter||Forum||Replies||Last Post|
|problem in tornado simulation with FLUENT, please help||Kestas||FLUENT||10||April 25, 2012 06:20|
|about valve closing problem during ANSYS FSI simulation||ivy||CFX||4||June 8, 2011 21:01|
|Large-scale simulation problem||Purushothama||Main CFD Forum||0||November 7, 2010 21:12|
|Problem restarting a simulation from an intermediate point.||sergiorbrett||CFX||2||April 21, 2010 17:11|
|problem of river flow simulation||Liu||Main CFD Forum||0||May 27, 2004 22:01|