CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] Refinement of premesh does not work (http://www.cfd-online.com/Forums/ansys-meshing/90002-refinement-premesh-does-not-work.html)

Mitpostdoc June 28, 2011 09:38

Refinement of premesh does not work
 
Hello there,
on the manual of Icem, under refinement, it's specified:
" A Level value less than 1 will result in coarsening of the pre-mesh"

However, if I specify a value less than 1, the program gives error saying "the factor must be positive".

What am I doing wrong? Why things in Icem never ever work as intended? :confused:

Thanks :)

Ludvik June 29, 2011 08:30

Don't write 0.5 but 1/2 (1/3, 1/4, 1/8, 1/9).

Mitpostdoc June 29, 2011 09:04

Thanks!
this is the weirdest thing I ever seen :P


All times are GMT -4. The time now is 19:48.