 |
 |
 |
|
|
|
[Sponsors] | ||||
June 28, 2011, 09:38
|
Refinement of premesh does not work
|
#1 |
|
New Member
Claudio
Join Date: Feb 2011
Posts: 20
Rep Power: 15  |
Hello there,
on the manual of Icem, under refinement, it's specified: " A Level value less than 1 will result in coarsening of the pre-mesh" However, if I specify a value less than 1, the program gives error saying "the factor must be positive". What am I doing wrong? Why things in Icem never ever work as intended?  Thanks 
|
|
|
|
|
|
June 29, 2011, 08:30
|
|
#2 |
|
Member
Join Date: Apr 2009
Location: Czech Republic
Posts: 65
Rep Power: 18 |
Don't write 0.5 but 1/2 (1/3, 1/4, 1/8, 1/9).
|
|
|
|
|
|
|
June 29, 2011, 09:04
|
|
#3 |
|
New Member
Claudio
Join Date: Feb 2011
Posts: 20
Rep Power: 15 |
Thanks!
this is the weirdest thing I ever seen :P |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] SnappyHexMesh Issues | deji | OpenFOAM Meshing & Mesh Conversion | 16 | October 20, 2021 07:13 |
| Mesh refinement and the errors. | Korsh Mik | CFX | 0 | January 11, 2006 07:07 |
| why my In-Form doesn't work? | green | Phoenics | 2 | May 27, 2004 21:03 |
| Mesh Refinement | JY | Siemens | 7 | September 19, 2002 13:37 |
| Grid refinement with wall functions | Mark Render | Main CFD Forum | 8 | May 2, 2000 07:09 |
Linear Mode
