CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   Trivial meshing problem (http://www.cfd-online.com/Forums/ansys-meshing/90539-trivial-meshing-problem.html)

shymoos July 13, 2011 09:32

Trivial meshing problem
 
Hi guys!
I just started working with Ansys Meshing software and I have following problem:
I'm starting with 2d straight pipe model. I would like to have mesh finer in near wall region, so I applied edge sizing on inlet and outlet boundaries, and this is what I have:
http://img220.imageshack.us/img220/1156/meshm.jpg
and this is what I would like to have:
http://my.fit.edu/itresources/manual...ug/img4744.gif (figure on the right).
I'm trying in every possible way, but I don't really know what to do. Please, explain it to me.

shymoos July 13, 2011 09:50

OK I resolved it. I just had to add "mapped meshing" control:)


All times are GMT -4. The time now is 12:14.