|
[Sponsors] |
July 13, 2011, 09:32 |
Trivial meshing problem
|
#1 |
New Member
Szymon
Join Date: Jul 2011
Posts: 2
Rep Power: 0 |
Hi guys!
I just started working with Ansys Meshing software and I have following problem: I'm starting with 2d straight pipe model. I would like to have mesh finer in near wall region, so I applied edge sizing on inlet and outlet boundaries, and this is what I have: and this is what I would like to have: (figure on the right). I'm trying in every possible way, but I don't really know what to do. Please, explain it to me. |
|
July 13, 2011, 09:50 |
|
#2 |
New Member
Szymon
Join Date: Jul 2011
Posts: 2
Rep Power: 0 |
OK I resolved it. I just had to add "mapped meshing" control
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with querying the meshing database in CFX-Pre | ashtonJ | CFX | 18 | April 18, 2023 23:49 |
[Other] Hex meshing problem DM12 | patrick | ANSYS Meshing & Geometry | 7 | January 9, 2015 07:21 |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
[ICEM] Hexa meshing blocking problem | fergal | ANSYS Meshing & Geometry | 0 | June 28, 2011 10:01 |
Meshing problem in GAMBIT | Vidya Raja | FLUENT | 0 | May 20, 2006 23:31 |