Can't import geometry file from Icem CFD to Ansys Workbench

Julien87 · July 19, 2011, 10:30

Hi everybody,
I created a geometry file with Solid Edge ST2 (*.par then via import geometry) to adapt it in Icem CFD 12.1.
Then I tried to load the adapted geometry file with Ansys Workbench 12.1 but it was not possible.
I attached the error message of Ansys below. (German version)

Thanks for helpfull answers,
Julien

Andrew.Coughtrie · July 19, 2011, 16:50

The easiest way to import a geometry into workbench would be to save/export the file as a parasolid file in ICEM so an x_t or x_b file as the workbench geometry modeller has a parasolid kernel and handles parasolid files better than any others such as IGES and SAT. So if you want to import a geometry to workbench that’s what I suggest.

Hope it helps

Andy

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ansys ICEM CFD Export to ascii MSH file?	EphemeralMemory	ANSYS Meshing & Geometry	1	November 19, 2010 16:43
DxFoam reader update	hjasak	OpenFOAM Post-Processing	69	April 24, 2008 01:24
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug	unoder	OpenFOAM Installation	11	January 30, 2008 20:30
DecomposePar links against liblamso0 with OpenMPI	jens_klostermann	OpenFOAM Bugs	11	June 28, 2007 17:51
[blockMesh] Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Meshing & Mesh Conversion	10	April 2, 2007 14:00

July 19, 2011, 16:50		#2
Andrew.Coughtrie Member Andrew Coughtrie Join Date: May 2011 Posts: 51 Rep Power: 14	The easiest way to import a geometry into workbench would be to save/export the file as a parasolid file in ICEM so an x_t or x_b file as the workbench geometry modeller has a parasolid kernel and handles parasolid files better than any others such as IGES and SAT. So if you want to import a geometry to workbench that’s what I suggest. Hope it helps Andy