 |
 |
 |
|
|
|
[Sponsors] | ||||
July 21, 2011, 10:39
|
Cell Numbering
|
#1 |
|
New Member
Join Date: Jun 2011
Posts: 5
Rep Power: 3  |
Hi all, I'm currently trying to interpret an exported ASCII file from ANSYS meshing. I've made sense of quite a lot of the information about faces and nodes but I'm struggling with information about whole cells.
Does anyone know of a way to display cell numbers in ANSYS meshing to try and help me understand how the file works? Any help, advice, or ideas would be greatly appreciated! 
|
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cells with t below lower limit | Purushothama | CD-adapco | 2 | May 31, 2010 21:58 |
| Cell numbering | sega | OpenFOAM Meshing Format & General Technical | 1 | April 20, 2010 11:32 |
| Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ... | 2 | July 15, 2005 04:15 |
| Warning 097- | AB | CD-adapco | 6 | November 15, 2004 04:41 |
| Cell numbering convention | Hassaneen | CD-adapco | 10 | August 14, 2000 03:36 |
Linear Mode
