Gambit Designing Problem

sumit singh · August 1, 2011, 08:09

hi
I am designing a cylinder say with 400mm height and 40mm radius in gambit. Now i want to use particular portion of wall say 200 mm from the centre to coat some material on that portion only. how can i separately use that portion of wall from the volume.
please suggest any solution
mail me at
sumit_nitj@yahoo.com

-mAx- · August 2, 2011, 01:08

post a sketch

sumit singh · August 2, 2011, 05:03

i have put the drawing. i want to use the 200mm height(as marked in drawing) cylinder for coating some paints on it inside a 500mm height cylinder.so it must be like a wall inside a volume. now how to separate this portion as a wall from the volume so that i can coat the paint.
i don't want that part to be a separate volume.

-mAx- · August 2, 2011, 05:11

create your wall as surface, and split your volume with this surface.
In the BC panel, assign your surface as wall.
If you don't do it, Gambit will define it automatically as interior

August 2, 2011, 01:08		#2
-mAx- Super Moderator Maxime Perelli Join Date: Mar 2009 Location: Switzerland Posts: 3,297 Rep Power: 41	post a sketch __________________ In memory of my friend Hervé: CFD engineer & freerider

August 2, 2011, 05:11		#4
-mAx- Super Moderator Maxime Perelli Join Date: Mar 2009 Location: Switzerland Posts: 3,297 Rep Power: 41	create your wall as surface, and split your volume with this surface. In the BC panel, assign your surface as wall. If you don't do it, Gambit will define it automatically as interior __________________ In memory of my friend Hervé: CFD engineer & freerider

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gambit geometry problem	cestrin	FLUENT	3	July 4, 2012 02:33
[Commercial meshers] Problem with Mesh conversion Gambit msh Foam	Rachid BANNARI (Bannari)	OpenFOAM Meshing & Mesh Conversion	25	September 11, 2011 07:58
Gambit - meshing over airfoil wrapping (?) problem	JFDC	FLUENT	1	July 11, 2011 05:59
Gambit installation problem	Panos	FLUENT	4	March 5, 2009 22:44
Problem importing iges file to Gambit	Tassos	FLUENT	0	May 7, 2008 04:28

August 2, 2011, 05:03		#3
sumit singh New Member sumit singh Join Date: Aug 2011 Posts: 8 Rep Power: 14	i have put the drawing. i want to use the 200mm height(as marked in drawing) cylinder for coating some paints on it inside a 500mm height cylinder.so it must be like a wall inside a volume. now how to separate this portion as a wall from the volume so that i can coat the paint. i don't want that part to be a separate volume.