|August 2, 2011, 16:03||
Join Date: Aug 2010
Posts: 16Rep Power: 6
I would like to mesh a torus which I created using the primitive geometry tools. I would like to make sure that each cross-section of the torus has the same mesh density and use quad elements. I am used to working with a 180 degree bend with a circular cross-section in which I am able to create size restrictions at a particular face and sweep the mesh along the arch of the bend. Since the torus is closed, I am unsure how to sweep the mesh.
Can anyone provide advice/ tips on sweeping the mesh for a torus geometry?
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing||David-CFD||ANSYS Meshing & Geometry||1||April 1, 2011 05:22|
|Meshing locks workbench window.||andy2o||CFX||0||February 1, 2008 06:01|
|Oddity in meshing half a torus||Maarten||FLUENT||0||March 12, 2004 09:04|
|Singularity of grid?Volume meshing vs face meshing||Ken||Main CFD Forum||0||September 4, 2003 11:09|
|Volume Meshing & Face Meshing? singularity of grid||ken||FLUENT||0||September 4, 2003 11:08|