CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [DesignModeler] problem using revolve (http://www.cfd-online.com/Forums/ansys-meshing/92070-problem-using-revolve.html)

elys September 1, 2011 07:33

problem using revolve
 
1 Attachment(s)
Dear all,

I have a problem concerning the revolve feature in Ansys' DesignModeler: I have managed to import points from a text file which I want to use to create a revolved geometry. I can import the points as a 3D Curve or as regular points which I can than convert to a line. So far so good, however, I can't apply the revolve feature because I cannot select a base object (which is usually a sketch - If I draw a polyline manually then I can use revolve without any problems, but I like to apply this feature to the imported points). What do I miss here? This must be easy ;) I am using Ansys 13 SP1

Any help is greatly appreciated!

Thanks in advance,

Ben

elys September 2, 2011 08:15

[Solved] revolve from 3D Curve
 
I just found out by myself. It is, as I already assumed, quite easy: Just apply a Named Selection to the curve first, then it is possible to use any feature like revolve or skin/Loft, etc.
This is for my understanding not very intuitive, but if you know that it is ok. ;)


All times are GMT -4. The time now is 15:07.