|
[Sponsors] |
September 12, 2011, 03:28 |
creating cuts on a volume
|
#1 |
Member
leila
Join Date: Jul 2011
Posts: 35
Rep Power: 14 |
hi
in gambit I want to creat a circular cut on top of a cylinder but it says "the requested operation can not be performed because the face of the cylinder has upper topology" do you know how it could be done? |
|
September 12, 2011, 07:05 |
|
#2 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
*post picture
*Real or virtual geometry?
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
September 12, 2011, 14:54 |
|
#3 |
Member
leila
Join Date: Jul 2011
Posts: 35
Rep Power: 14 |
the volume is real. how could it done?
|
|
September 13, 2011, 01:09 |
|
#4 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
if your volume is real, than a simple split with any surface cutting entirely your volume should be successfull.
But the message you posted, sounds like you want to delete a surface, an edge or a vertex which belongs to your volume
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 21:14 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |