CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   cut a face on a volume (real) (http://www.cfd-online.com/Forums/ansys-meshing/92377-cut-face-volume-real.html)

lili September 13, 2011 04:07

cut a face on a volume (real)
 
1 Attachment(s)
hi max
the pic attached is a spray dryer chamber that hot gas enters it from a ring hole on top of it. I want to creat a ring enterance on the top. is it clear?

-mAx- September 13, 2011 05:35

do you just want to isolate an annular face on the top face?

lili September 13, 2011 06:54

no. the annular face must be a part of the total volume and it must be meshed. I want to enter air from it in the chamber.

-mAx- September 13, 2011 06:58

so you want your top surface divided with a circle, which will describe your annular, right?

lili September 13, 2011 08:00

yes. on the top surface there is a ring from it hot gas enters the chamber.

-mAx- September 13, 2011 08:10

create the circle (edge), move it at it right position, and then split top surface with circle


All times are GMT -4. The time now is 00:02.