CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   Ansys Design modeler subtraction (http://www.cfd-online.com/Forums/ansys-meshing/93436-ansys-design-modeler-subtraction.html)

natantyt October 15, 2011 21:52

Ansys Design modeler subtraction
 
Hi

I have a complex agglomoration of particles in the design modeler, this agglomoration is bounded by a box. How can I make design modeler recognize the pore space. That means subtracting a complex geometry from a full box which gives acomples pore network.

Can anyone tell me the exact procedure?

Thank You,

Graham81 October 18, 2011 06:15

natantyt,

* Freeze both volumes (tools --> freeze)
* Create --> Boolean ---> Operation: subtract, target body: select box, tool body: select agglomeration. Preserve tool bodies? No

Good luck,

Graham

jstier2 November 7, 2011 16:27

Thank you soooo much!!! :)

umairjamil July 20, 2016 04:57

Fluid body problem
 
Dear All,
I am trying to do a DPM modeling for the flow dynamics of particles and air inside a spray dryer using ANSYS Fluent. My confusion might be under rated but I am stuck with it since a week now. The model apparently seems easy and might also be but I am confused about few things. I have attached a picture of the geometry as well as geometry file if someone wants to look into it.
Firstly, I am confused about the negative volume (fluid extraction) inside the spray dryer body. Should I use certain operations like fill or enclosure in order to model the flow dynamics or does assigning the body as Fluid body is enough?
Secondly as there an outlet pipe inside the dryer, I am not very sure how to proceed with this? Should the pipe be as a solid body or a fluid body? And should I use certain Boolean operations for the pipe like subtract or not? For now all the bodies I have kept as frozen.
I would be very grateful if anyone could give an insight to this problem. I merely need an advice or a guidance to what path or necessary steps I should follow that align with my problem. I look forward to helpful responses. Thank you very much.
Kind regards,
Umair Jamil

umairjamil July 20, 2016 04:58

Fluid body
 
Quote:

Originally Posted by Graham81 (Post 328379)
natantyt,

* Freeze both volumes (tools --> freeze)
* Create --> Boolean ---> Operation: subtract, target body: select box, tool body: select agglomeration. Preserve tool bodies? No

Good luck,

Graham

Dear All,
I am trying to do a DPM modeling for the flow dynamics of particles and air inside a spray dryer using ANSYS Fluent. My confusion might be under rated but I am stuck with it since a week now. The model apparently seems easy and might also be but I am confused about few things. I have attached a picture of the geometry as well as geometry file if someone wants to look into it.
Firstly, I am confused about the negative volume (fluid extraction) inside the spray dryer body. Should I use certain operations like fill or enclosure in order to model the flow dynamics or does assigning the body as Fluid body is enough?
Secondly as there an outlet pipe inside the dryer, I am not very sure how to proceed with this? Should the pipe be as a solid body or a fluid body? And should I use certain Boolean operations for the pipe like subtract or not? For now all the bodies I have kept as frozen.
I would be very grateful if anyone could give an insight to this problem. I merely need an advice or a guidance to what path or necessary steps I should follow that align with my problem. I look forward to helpful responses. Thank you very much.
Kind regards,
Umair Jamil


All times are GMT -4. The time now is 15:24.