|November 17, 2011, 15:52||
Surface mesh in the last layer
Join Date: Apr 2010
Posts: 61Rep Power: 7
I'm generating a mesh with prism layers following the procedure: Surface Mesh Only -> Prism Mesh -> Volume Mesh (from existing mesh)
After create prism layers (two prism for this example) one of the surface mesh part was moved acoording the new layers and new surface mesh was added.
I just want layers from orange part (see figures) so I needn't extra surface mesh in the border.
All suggestions are welcomed. Thanks
Edit: i know that I can solve it adding prism layers in the green surface, but I wanna know some solution without doing that.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Generating Mesh for STL Car in Windtunnel Simulation||tommymoose||ANSYS Meshing & Geometry||48||April 15, 2013 04:24|
|snappyHexMesh not refining surfaces||Hydro1004||OpenFOAM||3||August 29, 2012 11:56|
|non-smooth mesh||Svensson||OpenFOAM Native Meshers: snappyHexMesh and Others||11||January 18, 2012 10:13|
|Tweaked motorbike tutorial doesn't show my icosphere||mfiandor||OpenFOAM Native Meshers: snappyHexMesh and Others||0||October 9, 2011 18:39|
|snappy hangs while layer generation||bastil||OpenFOAM Native Meshers: snappyHexMesh and Others||3||October 29, 2010 07:19|