CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (http://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [DesignModeler] Design of catalytin converter (http://www.cfd-online.com/Forums/ansys-meshing/94552-design-catalytin-converter.html)

Sabrinache November 18, 2011 17:20

Design of catalytin converter
 
I am trying to design a catalytic converter which is a porous W-shaped in a square channel. So, I connected each part as a solid extrude with adding material and for square channel, I have connected as a surface body as solid. For fluid, I have used same dimension as surface body but by extruding as frozen. But how can I joint all the separated solid part of W ??? When I mention extrude as add material, are they already connected at junction? And also if I am not right, please give me advice.

Graham81 December 14, 2011 04:28

Extrude everything by "add frozen", then use Boolean-unite.


All times are GMT -4. The time now is 12:27.